Hello Node Kubernetes avaliações

Sin C. · Revisado há over 4 years

Command kubectl run does not create a deployment, it creates a pod and puts an image there.

Franciszek B. · Revisado há over 4 years

I didn't know how to use vi editor and i get stuck. It is not your fault but mine so I will give you full ratings. Also this command for creating de hello node didn't created it ready kubectl run hello-node \ > --image=gcr.io/PROJECT_ID/hello-node:v1 \ > --port=8080

Cristian B. · Revisado há over 4 years

Sathiyaprakash S. · Revisado há over 4 years

Tomasz G. · Revisado há over 4 years

Robert S. · Revisado há over 4 years

Need to change from "kubectl run hello-node \ --image=gcr.io/PROJECT_ID/hello-node:v1 \ --port=8080" to : kubectl create deployment hello-node --image=gcr.io/qwiklabs-gcp-00-7acc4a02b458/hello-node:v1

Ryan Hoon H. · Revisado há over 4 years

several commands do not work as described. kubectl run does not create a deployment but a pod, so all the following does not work if a deployment is not manually created. The dashboard and scaling seems to have problems as well.

Christian W. · Revisado há over 4 years

unable to connect 8080 port, i followed instructions and didnt work

miguel r. · Revisado há over 4 years

The kubectl run command did not create a depoyment. I had to create one before the rest worked

Ludovic L. · Revisado há over 4 years

Muhammad Fikri Bill G. · Revisado há over 4 years

some this worng in instruction

Pubudu D. · Revisado há over 4 years

Gabriela G. · Revisado há over 4 years

Raul S. · Revisado há over 4 years

Atichat P. · Revisado há over 4 years

Kritsadanshon S. · Revisado há over 4 years

Out of date on kubectl run. In version 1.18 it will create only a pod, not a deployment.

Bogdan D. · Revisado há over 4 years

Naoto K. · Revisado há over 4 years

Christopher M. · Revisado há over 4 years

和久 神. · Revisado há over 4 years

Sean s. · Revisado há over 4 years

Yulian -. · Revisado há over 4 years

Perhaps k8s commands have changed as below does not launch a "deployment". kubectl run hello-node \ --image=gcr.io/PROJECT_ID/hello-node:v1 \ --port=8080

Mike W. · Revisado há over 4 years

Divyang D. · Revisado há over 4 years

astrid b. · Revisado há over 4 years